Call us today
781-826-2525
781-826-2525
High Performance Linings
- Good chemical resistance
- Low viscosity, ships DOT non-corrosive
- Used on structural steel, equipment and tank exteriors
- Potable water version of HPL-1110
- Certified to ANSI/NSF 61
- Used on equipment and tanks for potable water
- Zero VOC concrete sealer
- Penetrates the concrete to provide strength and integrity
- Excellent adhesion to Duromar topcoats
- Low viscosity holding and penetrating primer
- Long pot life with good chemical and abrasion resistance
- Used as a holding primer for steel surfaces
- Trowelable material designed to rebuild and/or protect tanks subject to severe erosion and corrosion
- Can be easily be applied to a thickness of 90 mils in a single coat
- Best applied using a grout pump
- Used to rebuild or protection of steel tanks and vessels
- High gloss
- Low temperature curing
- Outstanding abrasion and chemical resistance
- Used on coal bunkers and process vessels
- Excellent flexibility
- High impact resistance
- Very good chemical and abrasion resistance
- Used on slurry tanks and process equipment
- Ambient cured, chemical resistant lining
- Ships DOT non-corrosive
- Used on process piping and tanks
- Long pot life, ambient cure
- Good mechanical properties
- Used on process tanks and circulating water lines
- A foul release version of HPL-2510
- Excellent longevity compared to typical silicone based systems
- Used on circulating water lines and intake structures
- An underwater curing and moisture tolerant version of HPL-2510
- Applied in a single coat up to 60 mils thickness
- Used on tanks, intake structures, circulating water piping
- Excellent abrasion and chemical resistance
- Low temperature curing capability
- Used on secondary containment, tanks and process vessels
- High temperature resistant coating
- Excellent abrasion resistance
- Used on incinerator outlets, flash drums and boiler skirts
- Ambient curing novolac epoxy
- Can be applied by conventional single component airless
- Used on power plant outlet ducts, chemical storage tanks, and process vessels
- High temperature resistant novolac material
- Applied by plural component airless
- Used on high temperature process equipment, electrostatic precipitators and mineral acid storage
- More chemical resistant version of HPL-4320
- Designed for constant immersion of highly concentrated sulfuric acid, mineral acids
- Used on concentrated acid storage tanks and vessels
- Flexiblized version of HPL-4320
- Good resistance to thermal shock
- Used on secondary containment, duct work or process vessels
- Trowelable novolac lining
- Outstanding chemical and abrasion resistance
- Used on duct work, tank walls, process vessels
- 100% solids epoxy with excellent color stability
- Good abrasion resistance
- Used on wind mills, water park slides, and exterior surfaces where color stability is required
- Clear topcoat with excellent UV stability
- May be applied at low temperatures, 40F minimum
